1996 YZ250 Power Valve Help

chillrich
Profile picture for user chillrich
Posts
648
Joined
4/1/2008
Location
Kamloops CA
chillrich 7/23/2014 8:49pm
7/23/2014 8:49pm
There is another piece, 19 or 21, I cant remember which one.It limits the travel of the powervalve, If it wears beyond spec the PV can hit the piston causing catastrophic failure, of course it was pricey too.
mustang413
Profile picture for user mustang413
Posts
23
Joined
8/8/2012
Location
Apex, NC US
mustang413 7/24/2014 11:00am
7/24/2014 11:00am
Thank you all for the quick replies. I believe it is part number 19. It is on the left side of the cylinder as if you were sitting on it. What I was hoping for was to be able to replace the brass(appears) collar and not the entire end. I cannot tell from the breakdown but the collar does not appear at all or is part of that end piece. I will take some photos tonight and attempt to upload them of the parts in question. The collar is so pitted and worn I am worried that if I put it back together that it will only be a matter of time until it catches the piston and no more 250.

Matt
mustang413
Profile picture for user mustang413
Posts
23
Joined
8/8/2012
Location
Apex, NC US
mustang413 7/24/2014 4:27pm
7/24/2014 4:27pm




Here are a couple of pics of the part in question. If I get part number 19 will it come with the brass collar. As you can see it is pitted and even has a deep divit on the outside. For almost 100 bucks I do not want to be wrong if I can get just the collar for 10. Thanks everyone who has chimed in.

Matt
FGR01
Profile picture for user FGR01
Posts
5113
Joined
10/1/2006
Location
AZ US
Fantasy
1327th
FGR01 7/25/2014 10:15am
7/25/2014 10:15am
Hard to say. Looking at the diagram, obviously the brass part is not sold by itself. But it could come either on the end piece or pressed into the powervalve itself. My bet is that it would come with that end piece. It's probably pressed on there from the factory and isn't supposed to come off. Yours is probably so worn and that;s why it comes off. If it was me, I would try to get a machine shop to make another and press it on there. Shouldn't be too hard.

Post a reply to: 1996 YZ250 Power Valve Help