Added reply in a thread Nemx vs Nesc 12/27/2016 10:33 AM

I'm not sure that I'd label Pete as one of the toughest guys but I'd certainly say in my 30+ yrs of knowing and racing against him that he's without a doubt one of the nicest and most helpful guys that you'll ever meet. He's definitely one smartest and ... more »

Added reply in a thread For CR250#132 12/27/2016 10:15 AM

and..... I just spit my drink out!! :-)

Added reply in a thread WTB 2015.5+ Trax shock 12/23/2016 7:30 AM

I have a set of the new 16 black cone valves and trax shock here at my house that I'm going to clean up and list for a buddy in the next few days. Set up for 180lb expert MX.

Added reply in a thread Fox Instinct LE Boots 12/12/2016 8:01 AM

Same here, I was given a pr of the prototype Instincts in the spring of 12 and been wearing Instincts ever since. Most comfortable and best boot I've ever worn. Zero break in required. I've taken a new pr right from the box and raced that day with them. ... more »

Added reply in a thread Ktm 350 sxf 2016 fork pressures 12/3/2016 11:36 AM

No problem. I just wanted to let you know that me and everyone that I race with here in New England are running our AER's way softer than they're spec'd from KTM. The chart goes something like this 125/150SX 8.6 bar 250SX 10.2 bar 250SX-F 10.6 bar 350SX-F ... more »

Added reply in a thread Ktm 350 sxf 2016 fork pressures 12/3/2016 10:34 AM

Yes definitely. For what it's worth I only ran my AER's for the final 3 races of our season here in New England and I started at 148psi in them which is where they come stock and that I mentioned in my earlier post. I actually kept going down until the ... more »

Added reply in a thread 2017 ktm traction control switch 12/3/2016 10:26 AM

No, I don't think so because the 17's don't have the dial switch in the airbox like our 16s do.

Added reply in a thread Ktm 350 sxf 2016 fork pressures 12/3/2016 7:17 AM

You should be around 10.4 -10.6 bar.

Added reply in a thread 2017 Husqvarna FC450 - FINISHED 12/3/2016 5:51 AM

Those radiator caps are available on Mishimoto's site.

Added reply in a thread 2015 ktm 450 FE electrical help? 12/2/2016 7:01 AM

Definitely recheck the ground with an ohm meter. Also check the plug closely behind the front numberplate because I've seen 2 of them where a wire had pulled out of the plug and it was hardly noticeable but was causing the exact problem that you're describing. ... more »

Added reply in a thread Will KTM produce a 2017.5 FE? 11/26/2016 12:21 PM

There will absolutely be a 17.5 FE and it will be out sooner than you think :-)

Added reply in a thread Cone valve question 11/26/2016 8:33 AM

No problem and good luck. You're going to love the forks.

Added reply in a thread Cone valve question 11/26/2016 7:55 AM

It's a very thin 34mm wrench.

Added reply in a thread 2017 Husqvarna FC450 - FINISHED 11/26/2016 6:44 AM

Love the new stadium plate and the KTM fender on it. Much cleaner looking. I'm definitely getting that new plate for my new FE because my clamps were rittled with roost marks from this season. I had 98 Ti bolts and Think seat foam, full Ti FMF system ... more »

Added reply in a thread Cone valve question 11/26/2016 6:30 AM

I'll go out in my trailer and measure it for you as soon as we get back from getting our x-mas tree.

Added reply in a thread Machining Billet Ti Footpegs - Video 11/25/2016 10:22 AM

I'm 99% sure that the KTM 50/65 pegs are the very same peg that fits the big bikes.

Added reply in a thread 2017 sxf450 front axle/fork issue 11/24/2016 7:22 AM

I've seen it a few times and those forks need to repaired immediately. As Flipsid said your air pressure is leaking into your outer chamber. Don't ride the bike.

Added reply in a thread Husky/KTM Axle Blocks? 11/19/2016 5:40 AM

Thanks :-) and the whole set up the axle cost me under $100. Worth every penny because of the ease of adjusting the chain. Factory KTM uses a very similar set up with the non threaded side and my guy at KTM says they have rear shock data that shows that ... more »

Started new thread 3 pr of new Fox Instincts size 11 11/18/2016 9:35 AM

I have 3 pr of brand new in the box Fox Instincts all size 11. I'm selling them for a friend who broke his leg and won't be riding anytime soon if ever again. I bought all of his gear but the boots are too small for me. There is a red pr, white pr and ... more »

This forum thread has 1 reply

Added reply in a thread Husky/KTM Axle Blocks? 11/17/2016 4:01 PM

Get the Ride Engineering axle blocks. It uses a CRF450 axle and the sprocket side isn't threaded on and it makes adjusting the chain SO much easier.